Lazervida Shield

組裝費時，縫隙大…，壓克力的保護膠撕除也很困難費時… 螺帽使用壓克力材質容易滑牙，對於組裝密度影響不小，即便雕刻的氣味有改善…但若能有更好的氣味阻隔設計會是更好的產品。另外組裝指引不夠清楚，影片的方式還有更細節的拍攝，若能有電子檔的紙本教學會更好，如同IKEA傢俱的說明書就非常清楚，且因為沒有防呆設計，千辛萬苦組裝好了卻發現上下裝顛倒導致上蓋無法安裝、或是線材出口方向錯誤還得再辛苦一次…線材出口若能提供橡膠氣密塞會更理想！

Thank you for making the free plans available for the enclosure. It would help if the files included assembly instructions with a list of materials such as the recommended hinges for the lids and hardware for the panels. There is a *.DS_Store file, but it cannot be opened as a .txt, .doc, or .pdf, and it is not a link.

For example, photos of the enclosure show what might be rivets or screws holding the panels together. In the files, these would enter a hole in the facing panel and continue into a pinched recess in the abutting panel (e.g., front and L side). What's the hardware?

Also, there are two bottom panel files: Bottom_Panel_F and Bottom_Panel_B-1028. F has a row of small holes along the back; B-1028 does not. But there is only one back panel file. Which bottom panel should we choose; what situation does it depend on?

整體上來說, 還不錯! 自己買壓克力來組一定超過售價.
上蓋蝴蝶頁的螺孔太大 以及風管有公差, 但客服很快速的幫我解決問題.
客服也很不錯!

買~

加了吹氣模組後不管是切割或是雕刻時的燒焦情況都有明顯改善。

外罩會因鎖付螺絲時的累積公差而無法順利卡進卡榫,可以再放寬卡榫公差。

外罩因沒有風扇抽風,將Beam Air開到最大的吸風效果還需要加強。

Flux make good laser-engraving machine for individual-studio.